|
Anchor
Jan 26, 2013 15:55:19 GMT -1
Post by greatwhite on Jan 26, 2013 15:55:19 GMT -1
I want to anchor my yak at sea, at the low water tide, and fish until an hour before high water. I shall anchor about 50 70 feet from a gully/channel so that it is between the land and me. This way, I shall be able to always place my bait, right into the gully/channel, which runs parallel to the advanced tide.
That is my plan.
Another fisherman, with a lot of experience with boats, is against this. He says that it might be dangerous, claiming that boats can be dragging under the water.
Is this just sour grapes because he can't swim ? Or is his warning valid ?
|
|
|
Anchor
Jan 26, 2013 17:19:30 GMT -1
Post by BUDDY on Jan 26, 2013 17:19:30 GMT -1
Hi. His warning is valid. Depending on the rip or speed of the chanel when the tide is running. Local knowledge is usually the best advice. If in doubt put up the exact location and if any members know the area you will get more replies. Steve
|
|
|
Anchor
Jan 26, 2013 18:09:54 GMT -1
Post by greatwhite on Jan 26, 2013 18:09:54 GMT -1
I am thinking of Ainsdale, close to Southport
|
|
|
Anchor
Nov 25, 2013 19:47:19 GMT -1
Post by nala on Nov 25, 2013 19:47:19 GMT -1
Also a good idea to check your local charts and see what the seabed in made of..............they give depth and tidal streams.(different anchors for different applications) The symbols are usually on the back..? It'll give you an idea of what type of anchor to use on that particular sea bed......? Also check whether the tide is at neap or spring,or in between ? Springs have the strongest flood of tide and strongest flow... So,you should avoid that unless its safe......if in doubt leave it out ! 4 x times the depth for rope and warp is a good place to start ie calm water.......ie 10ft of depth = 40ft of rope to pay out. That's just a guide if there's a swell (or a gusty wind)then you have to adjust accordingly. Remember to adjust,ie pay out if tide is on the flood and retrieve if the tide is ebbing. All this is to ensure the anchor holds you and maintains your position. Check transits to see if you are holding...ie two landmarks Church steeple,pylon,mast,building and or a tree.... If you've got a GPS check your position........mark a waypoint and check your bearing. You'll soon know if your drifting..... Pick up anchor and re-try further up tide.... And remember your fishing weight will drift too.... So you have to take that into account..
|
|
|
Anchor
Dec 22, 2013 14:19:23 GMT -1
Post by greatwhite on Dec 22, 2013 14:19:23 GMT -1
Hi nala Thanks for this !
At Ainsdale/Southport we have a sea that goes out for miles, and then comes right back in again. It is quite shallow,that is the impression. But at the low water mark it could be 30+ feet high at high water.
I am thinking of knowing for sure what it is. I shall use algebra to know for sure, but first, I shall need to buy a laser. I would hate to run out of rope and cause a capsize .
|
|